After flushing has been completed empty remaining water used for flushing from the tank reservoir,
replace the cap and store the ULV until ready to re-use.
Ideal Setting
1. Adjust Spray Mist using “Adjustable Settings” Valve.
2. Fine Mist (RECOMMENDED) - Fully Close Valve then open 2 turns to maximum of 2.5 full turns.
3. Apply EnviroNize® Disinfectant solution 3 meters or 10 feet from target area with one pass to apply light non wet mist application.
4. Thoroughly BLOW DRY misted area within 1 minute so target area is dry and free of any moisture should mist encounter any electrical component or non-stainless-steel metals.
1. Adjust Spray using “Adjustable Settings” Open Valve.
2. Wet Mist (Non-Metal, Non-Electrical and Non-Painted Porous Surfaces) - Fully open the valve. This will provide maximum wetness. Adjust to desired wetness of spray by slightly closing the valve.
3. Apply EnviroNize® Disinfectant solution (Non-Metal, Non-Electrical and Non- Painted Porous Surfaces) 2 meters or 6 feet from target area. Let air dry.
1. Adjust Spray using “Adjustable Settings” Valve and set to fully closed position. BLOW DRY FEATURE: To be used when misting near and on any metal, electrical components or high- tech lighting:
2. Fully Close the Valve (No Solution) - Turn EnviroNize® ULV to maximum on position to provide just air only NO SOLUTION - Thoroughly BLOW DRY misted area within 1 minute so target area is dry and free of any moisture.
3. Apply BLOW DRY FEATURE 1 meter or 3 feet from target area.